Table of Contents
Advertisement
3
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
on the rear of the projector.
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed
:
ON
Not pressed
:
OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode', depending on the software
setting in the service menu of the projector . This is done during installation by a qualified technician. If you want to change
this start up mode, call a qualified technician.
Stand by indication lamp :
No light up
:
Projector in operational mode
Red
:
Projector is in stand by.
Leds on the rear plate of the projector
Signal input connection to the projector :
- Composite Video
- S-Video
- RGB
- YUV (component input)
Note :
All sync types accepted and Muse HDTV Standard accepted.
Source No Projector
1
Comp. Video
2
S-Video*
3
RGB/15K/32K
4
HDTV(Gs)
Muse
5
YUV
6
YUV on HDTV
* Input signal Y/C (luma/chroma)
On RGB / YUV
Synchronizing Signal Types Accepted are
1. Gs - Sync. on Green BNC
2. H,V sep - Horizontal and Vertical Sync. separate on H and V BNCs
3. CS - Composite Sync. on H BNCs
Sync. accepted on both positive and negative polarities for 2 and 3
Connecting a Composite Video source
Composite video signals from a VCR, OFF air signal, decoder, etc.
R5976381.01 BARCO CINE6 31012002 __________________________________________________________________________
CONNECTIONS
input
Press digit
1
2
3
4
5
6
120/230v
4 A/2.5A
60/50 Hz
300 W
•
Stand By / Operational
•
Pause
•
Sync
•
Hold Down EHT
•
IR
Composite
Video
TV Tuner
V C R
Connections
Audio
Amplifier
4-1
Advertisement
Table of Contents
