Advertisement
67.
Installation of 6 Polygal Panels is next. Start by removing protective plastic layer from each
panel. Exterior/Interior side of protective polygal film is printed on film, be sure to note the side and
install accordingly. Slide panel between rafters so it rests on Polygal Support Cleats. From the
inside, carefully slide end of Polygal Panel underneath roof. Position Polygal Panel equally
between rafters and overhanging end of rafter by 1".
68.
Drill pilot holes with 1/8" bit through Polygal Panel and Polygal Support Cleat once
aligned. With 6 - 1" screws, secure panel to Polygal Support Cleats. Polygal is delicate, tighten
screws a half turn at a time so screws are flush with top of Polygal Panel. Use 3 - 1" screws to
secure to underside of Roof Batten.
69.
Position and secure remaining Polygal Panels as per Steps 67-68. Once all panels are
secured, apply Silicon to seal gaps between rafters and Polygal Panels. Apply Silicon down each
side of Rafter. Use liberal amounts to properly seal.
Toll Free 1-888-658-1658
www.outdoorlivingtoday.com
Page 34
sales@outdoorlivingtoday.com
Advertisement
