Advertisement
15 3/4" Batten
Spacer
56.
Position 1st row of Outside and Inside Battens on non-polygal side and attach as
per Steps 51-52. Attach Batten Spacer Long (3/4" x 1 1/2" x 15 3/4") below 1st row of
Battens. Continue attaching Spacers and Battens as per Steps 53-55 until you com-
plete all 5 rows. Final Row near soffit should land 3/8" from end of Rafter. Use a total
of 61 - 1 1/4" screws to complete non-polygal side of roof.
57.
Starting on the non-polygal side, locate 4 Long Metal Roof Panels (39" wide x 86" long)
and 4 Metal Roof Hangars. To temporarily hold the Metal Roof Panels in place, hook a Metal
Roof Hangar onto the lowest Batten approximatley Where the center of the first Panel will be.
Place the first Metal Roof Panel on Battens. Do not fasten Panels down until Step 62. Place
Remaining 3 Panels and Hangars on the same way. Metal Roof Panels overlap eachother.
Toll Free 1-888-658-1658
Important: Do not fasten down Roof
Panels with Hangars still in place.Metal
Roof Hangars will temporarily help keep
Metal Roof Panels in place before they are
fastened.
www.outdoorlivingtoday.com
Page 30
2 Outside Battens
1 Inside for every row
sales@outdoorlivingtoday.com
Advertisement
