Advertisement
24.
Locate Vertical Door Jamb and position flush against right wall panel stud. The Jamb is 3 1/4"
wide and will sit flush to outside of wall siding. When positioned correctly, secure Jamb using
4 - 2 1/2" screws.
25.
Position and attach the Door Header to Door Jamb and Narrow Wall Panel top framing. Header
should sit flush with Door Jamb and Outside of Narrow Wall Siding. Attach with 4 - 2 1/2" screws.
Toll Free 1-888-658-1658
Jamb sits flush
with Wall framing
Advice: Prior to fastening walls and installing
rafters, take time to confirm your walls are
level, square and plumb.
Measure diagonal at top and bottom of walls
corner-to-corner. This should be approximately
189 3/8". More importantly, if measurements
are not within 1/4", your walls are not square.
Adjusting now will make it easier to the roof
section later
www.outdoorlivingtoday.com
Page 15
Jamb sits flush
with tips of siding
Dado cut on edge to
top and outside.
.
sales@outdoorlivingtoday.com
Advertisement
