Advertisement
B. Wall Section
12.
Starting with Solid Wall Panels, carefully lay panel face down. Position and attach Wall Plate
to bottom of wall studs of each wall panel with 3 - 2 1/2" screws. Position so plates are flush with
framing. Note: bottom Wall Plates may already be attached to some Solid Walls.
13.
Starting at Rear Corner, position a Solid Wall Panel on top of plywood floor. Make sure panel is
facing up. The side wall panels will sit flush with floor frame with the front and rear panels sandwiched
between them. Note: siding will overhang the floor by approx. 1/2".
14.
Position rear Window Wall Panel into place on plywood floor. Butt both vertical wall studs of side
and rear walls together and attach with 3 - 2 1/2" screws. Screw at the bottom, middle and top of
stud to secure properly.
Toll Free 1-888-658-1658
Bottom Wall Plate
Important: Make sure all walls are
aligned in their upright position. If
not ,water may leak into your shed.
Unsure if panel is facing up or
down? check siding on window wall
panel to match alignment.
Optional:
Small bead of
Caulk on wall
frame first.
www.outdoorlivingtoday.com
Pilot hole ALL 2x3 Wall Studs
with 1/8" drill bit prior to screwing.
This will make it much easier to
Side Wall Panel
2x3 Plate of wall panel is
flush with floor frame. Siding
overhangs floor by 1/2".
Page 11
Important:
attached together.
Pilot
Hole Plate
first.
sales@outdoorlivingtoday.com
Advertisement
