42.
Lift second Rafter Section up and
place on Gable framing. Slide Rafter
Section up on framing until bottom of
Ridge Board slips into Gable notch.
Soffit will sit approximately 1/8" away
from wall as per Step 41.
Ensure Ridge
Boards are flush.
Bottom of Ridge Board
fits in gable notch.
43.
Take the inside-to-inside measurement between Top Wall Plates and Bottom Wall Plates at the
front, middle, and rear of your shed. These measurements should each be approximately 136 1/2", but
more importantly, if they are not within 1/4" of each other, your walls are not square.
Toll Free 1-888-658-1658
www.outdoorlivingtoday.com
Page 24
sales@outdoorlivingtoday.com