Advertisement
48.
Attach all Single and Double Rafter
Brackets where rafters meet Top Wall
Plates inside of shed. Attach with 2 - 1 1/4"
Screws and 2 - 2" Screws per Single
Rafter Bracket and 6 - 2" Screws per
Double Rafter Bracket.
1/4" gap
49.
Position a 3/4" x 3/4" x 48" long Polygal Support Cleat on each Long Rafter flush to end and
recessed 1/4" down from top of rafter. Nail to rafter using 6 - finishing nails. Note: Start nails in Supports
on ground first. Further secure with 2 - 1 1/4" screws - see diagram above. Complete remaining 11
Polygal Support Cleats.
50.
Position Triangular Gable Trims (4)
in each corner of exposed cavity of Gable
Wall. Use 2 finishing nails each to secure
into rafter.
Toll Free 1-888-658-1658
Further
2 - 1 1/4" screws. Important: Drill
pilot holes to prevent splitting!
Note: Triangular Gable Trims are
found inside gable corner behind
scrap piece marked with "X".
www.outdoorlivingtoday.com
2" Screw
2" Screw
2" Screws
secure
Cleats
Triangular
Gable Trims
Page 27
1 1/4" Screw
2" Screws
with
sales@outdoorlivingtoday.com
1 1/4" Screw
Advertisement
