Advertisement
58.
Overhang the Metal Roof Panels past the Battens on sides by approximatley 1". Adjust
panels side to side to achieve desired width Overall width past the Battens can vary from 1" -3 "
depending on your preference. The overhang over the side of the shed will be set by the Metal
roof Hangars, but should be approximatley 4" on the side of shed.
Bead of Caulking
59.
Once Metal Roof is spaced correctly from side-to-side and top-to-bottom, lift 3 panels up and
run a bead of caulking down the overlapping seams of each panel to seal the joints. Place panels
down one by one once seam is caulked. You will likely need assistance from a helper for this step.
Caulk each seam.
60.
Using 6 - 2" Metal Screws and 1/4" Nut Driver (included), partially secure Metal Roof
Panels down to middle Batten row. Only fasten screws halfway so that the Metal Roof Hangars
can be removed. Metal screw is self-tapping, screw into the center of Battens. Eighteen more 2"
Metal Screws and six more 7/8" screws will be required to further secure Metal Roof Panels and to
complete Metal Ridge Caps in later steps once Metal Roof Hangars are Removed.
Toll Free 1-888-658-1658
Approximatley 4"
of overhang.
Note: Metal Roof Hangars will
be removed in Step 61.
www.outdoorlivingtoday.com
Page 31
Bead of Caulking
sales@outdoorlivingtoday.com
Advertisement
