Advertisement
Important: If walls are not lining
up and appear higher or lower than
each other, please check the level
of your floor. You may need to
make slight adjustments before
proceeding.
26.
When all walls are attached
together, check alignment with the
floor. Bottom wall framing should
sit flush with outside of floor joists.
When positioned correctly, fasten
bottom wall plates to floor using
4 - 2 1/2" screws per wall panel.
Confirm 32" wide door opening
at bottom.
Angle
screws into perimeter
Floor Joists.
Top Plates
27.
Position Front Top Plates on top of wall framing so they are flush on the inside with 2x3 wall
frame. There are 2 Front Top Plates. Together, the plates should be centered evenly on the wall left to
right. Attach by screwing down into top wall framing with 4 - 2" screws per Plate.
Toll Free 1-888-658-1658
Bottom Wall
Framing
Optional: Caulking seams will
help prevent moisture from
entering your shed. Caulking
is included to complete polygal
Windows
only.
Additional
Caulking may be required.
Angle cut
on 1 end.
www.outdoorlivingtoday.com
Page 16
Top Plates should
be flush with inside
of wall framing.
sales@outdoorlivingtoday.com
Advertisement
