Xilinx Virtex-7 FPGA VC7222 Getting Started Manual page 16

To configure the FPGA using the SD card:
1. Insert the SD card provided with the VC7222 board into the SD card reader slot located
on the bottom-side (upper-right corner) of the VC7222 board.
2. Plug the 12V output from the power adapter into connector J2 on the VC7222 board.
3. Connect the host computer to the VC7222 board using a standard-A plug to Micro-B
plug USB cable. The standard-A plug connects to a USB port on the host computer and
the Micro-B plug connects to U57, the Digilent USB JTAG configuration port on the
VC7222 board.
4. Select the GTH IBERT demonstration with the System ACE™ SD Controller SYSACE-2 CFG
switch, SW8. The setting on this 4-bit DIP switch
configure the FPGA. A switch is in the ON position if set to the far right and in the OFF
position if set to the far left. For the Quad 115 GTH IBERT demonstration, set ADR2 =
ON, ADR1 = OFF, and ADR0 = ON. The MODE bit (switch position 4) is not used and can
be set either ON or OFF.
X-Ref Target - Figure 1-9
There is one IBERT demonstration design for each GTH Quad on the VC7222 board, for a
total of six IBERT designs. Additional designs are provided to demonstrate the GTZ and the
USB/UART interface (details of this demonstration are described in the README file on the
SD card). All eight designs are organized and stored on the SD card as shown in
Table 1-1: SD Card Contents and Configuration Addresses
Demonstration Design
GTH Quad 113
GTH Quad 114
GTH Quad 115
GTH Quad 213
GTH Quad 214
GTH Quad 215
GTZ Quad 300A and 300B
USB/UART
5. Place the main power switch SW1 to the ON position.
VC7222 IBERT Getting Started Guide
UG971 (Vivado Design Suite v2015.1) April 27, 2015
Figure 1-9: Configuration Address DIP Switch (SW8)
ADR2
OFF
OFF
OFF
OFF
www.xilinx.com
Chapter 1: VC7222 IBERT Getting Started Guide
(Figure 1-9) selects the file used to
ADR1
ON ON
ON ON
ON OFF
ON OFF
ON
ON
OFF
OFF
Table 1-1.
ADR0
ON
OFF
ON
OFF
ON
OFF
ON
OFF
16
Send Feedback