GSi GrainVue Installation Manual page 35

Installing the Permanent Power Cable
NOTE: Your system will come with 3 AC or DC relays that are pre-installed. The type of relay was
determined at time of ordering. If you need to change them to a different type, please contact
GrainVue:
Email: support@grainviz.com or
Phone: 431-688-2068
Only a certified electrician can complete the power supply installation. Make sure all
power sources are disconnected before performing any maintenance or service.
WARNING
Always follow all national and local electrical and safety regulation for your area.
1. Disconnect and remove the supplied power cable (15) from the Fan Control Module (18) rail
components shown in the image below.
Figure 5-9 Removing the power supply cable
15 Power cable
PNEG-2347 Cable Monitoring System
Chapter 5: Installing the Power Supply
18 Fan Control Module
35