Henny Penny FlexFuison GOLD FGE-615 Installation Manual page 8

Safety information
2
Setup
Electrical connection
Commissioning
8
▪ Attach the unit to the lifting gear securely during transport and setup, and
prevent it from dropping.
▪ Transport the unit in an upright position, do not tilt or stack.
▪ Pay attention to protruding parts when transporting the unit without
packaging.
Risk of property damage and personal injury from improper
setup
▪ Ensure that the installation area has adequate load-bearing capacity.
▪ Where safety shoes and protective gloves.
Risk of fire from improper connection
▪ Observe applicable regional regulations of the electrical utility.
▪ Ensure that only licensed electricians connect the unit.
▪ Ensure that the electrical system is earthed by a protective earthing
conductor.
▪ Note the information on the nameplate.
Risk of electric shock from live components.
▪ Prior to working on the electrical system, switch off the unit, disconnect
the electrical system from the mains and prevent power from being
switched on again. Check to ensure absence of voltage.
Risk of property damage and personal injury from improper
commissioning
▪ Read the operating instructions prior to commissioning. Observe the
safety instructions in this installation manual and in the "Safety
information" chapter of the operating instructions.
▪ Put the unit into service only after a successful function test following
assembly.
▪ Put the unit into service only after it has reached room temperature.