KROHNE OPTIWAVE 7300 C Handbook page 59

OPTIWAVE 7300 C
Menu No. Function
B.1.4
B.1.5
B.2
B.2.1
B.2.2
B.2.3
B.2.4
B.2.5
B.2.6
B.2.7
B.2.9
01/2008 • 4000172401 - HB OPTIWAVE 7300 R03 en
Function descritpion
set output 2 This sets analogue output 2 to a
test value [mA] selected from a
list. Output will change to the
selected value, independent of
the measured value.
internal test This initiates the hardware test.
The device displays the results.
information a summary of information
relating to the device
outputs analogue output settings. This
includes assigned functions, 4
... 20 mA scale settings,error
handling and HART®
parameters.
15 minute log a log of output values for the
last 15 minutes. A log is taken
every 10 seconds and displayed
on a graph.
device This displays device order no,V-
identification no, service no, firmware 1
version, firmware 2 version,
firmware 3 version and Ex
approval details.
quick setup a summary of the parameters
summary entered in the quick setup
menu
TAG number The TAG number can be seen
and updated here
error records a log of instrument errors.
Scroll down the list and press
^ to display the error details.
Opening a log will remove the
error icon if it appeared in
operator mode.
customer non-standard length unit for
length unit the conversion table. This is
defined by the supervisor. Go to
supervisor > advanced setup >
device setup > display settings
> customer length unit or
follow the conversion quick
setup procedure.
customer non-standard conversion unit
conversion unit for the conversion table. This is
defined by the supervisor. Go to
supervisor > advanced setup >
device setup > display settings
> customer conversion unit or
follow the conversion quick
setup procedure.
Selection list
3.6, 4, 6, 8, 10, 12, 14, 16, 18, 20
or 22 mA
read only
read only
read only
read only
read only
?
read only
read only
read only
www.krohne.com
OPERATION
6
Default
4 mA
TAGNO0
1234567
890
59