KROHNE OPTIWAVE 7300 C Handbook page 105

OPTIWAVE 7300 C
How to remove the display
Remove the 2 pins on the blue sun cover with a flat screwdriver. Remove the blue sun cover.
1
2 Loosen the screw on the display screen cover. Open the display.
Disconnect the ribbon cable from the back end electronics block.
3
Keep the ribbon cable connected to the display screen cover.
i
Remove the 2 screws that keep the display attached to the housing.
4
Keep the remaining assembly and put it into storage. Make sure that the top of the housing
5
has a protectiive cover.
6 Send the display to an authorized agent for maintenance.
How to attach the display
• Attach the display. Attach the 2 housing screws.
• Connect the ribbon cable to the back end electronics block.
Make sure the connector is correctly turned. Do not use force to connect the ribbon cable.
i
• Close the display. Tighten the screw on the display.
• Attach the blue sun cover. Attach the 2 pins that keep the blue sun cover attached to the
housing.
01/2008 • 4000172401 - HB OPTIWAVE 7300 R03 en www.krohne.com
SERVICE
9
105