KROHNE OPTIWAVE 7300 C Handbook page 56

OPERATION
6
Menu No. Step
sub-
menu
sub-
menu
56
Function
conversion
submenu [mass]
1 free unit
2 table length unit
3 conversion wizard
4 type in product
density?
5 product density
6 type of product
7 tank shape
8 conversion unit
9 conversion table
conversion
submenu [free
unit]
1 free unit
2 customer length
unit
3 customer length
ratio
4 customer
conversion unit
5 No. Of LVM Entries
6 conversion table
... save / cancel
Function description
This sub-procedure
uses the information
given here to find the
volume. You have to type
in the tank shape,
height, width and length.
The conversion unit is
given as a volume if the
product density is given.
If not, choose a mass
unit.
A table that converts
product level to product
mass.
If you cannot find the
units or tank shape in
the menu, you can
customize the
conversion table.
A non-standard length
unit for the conversion
table. This is defined by
the supervisor.
The conversion factor
between the length unit
selected in C.5.1.4
(length unit) and C.5.1.7
(customer length unit).
This ratio is a multiple of
1 mm.
A non-standard
conversion unit for the
conversion table. This is
defined by the
supervisor.
The number of lines in
the conversion table.
A table that converts
product level to another
physical parameter.
www.krohne.com
OPTIWAVE 7300 C
Selection list
-
yes, no
m, cm, mm, inch, ft,
free unit
mass
yes, no
min-max:
0...20000 kg/m3
solid, liquid
...
m³, L, US gal, GB gal,
ft³, bbl or Tons, kg, US
Tons, GB Tons
-
yes, no
min-max: 1...99999
min-max: 0...50
save, cancel
2
01/2008 • 4000172401 - HB OPTIWAVE 7300 R03 en
Default
no
m
m
yes
0
...
flat
no
LEN_
FREE_
1
CO_FR_U
N
2
save