OPTIWAVE 7300 C
Equipment needed (not supplied):
•
3 mm Allen wrench (for step 1).
•
2.5 mm Allen wrench (for step 5).
•
TORX T10 (for step 6).
How to remove the terminal module
Loosen the cover stop screw on the terminal compartment cover.
1
Remove the terminal compartment cover.
2
Remove the plastic terminal cover.
3
Disconnect the wire connector from the back end electronics compartment.
4
5
Loosen the 2 screws shown in the illustration.
Loosen the screw for the earth terminal connection.
6
7
Remove the terminal block from the housing. Send it to an authorized agent for maintenance.
How to attach the terminal module
•
Put the terminal block into the housing.
•
Attach the earth terminal connection to the housing with the screw supplied.
•
Attach the terminal block to the housing with 2 screws supplied.
•
Connect the wires from the electronics compartment.
•
Attach the plastic terminal cover.
•
Attach the terminal compartment cover.
•
Tighten the cover stop screw.
01/2008 • 4000172401 - HB OPTIWAVE 7300 R03 en
www.krohne.com
SERVICE
9
109