Table of Contents
Advertisement
Figure 11: Turn-off Timing through AT Command and FULL_CARD_POWER_OFF#
Table 11: Turn-off Time through AT Command and FULL_CARD_POWER_OFF#
Symbol
Min.
T
6.84 s
turn-off
NOTES
1. After the host detects that the module USB/PCIe is removed, FCPO# pin must be pulled down.
2. After turning off the module, it is recommended to cut of VCC power supply.
3.6. Reset
RESET# is an asynchronous and active low signal (1.5 V logic level). Whenever this pin is active, the
module will immediately enter Power On Reset (POR) condition.
Table 12: Definition of RESET# Pin
Pin
Pin Name
No.
67
RESET#
RM510Q-GL_Hardware_Design
3.7 V
1.5 V
≥ 1.19 V
V
IH
1.8 V
1.8 V or 3.0 V
Running
Typ.
Max.
-
-
I/O
Description
Reset the module
DI, PU
Active LOW.
AT+QPOWD
USB/PCIe removed
Turn-off procedure
T
turn-off
Comment
System turn-off time
DC Characteristics
V
max = 1.575 V
IH
V
min = 1.25 V
IH
V
max = 0.45 V
IL
5G Module Series
RM510Q-GL Hardware Design
OFF
Comment
Internally pulled up to
1.5 V with a 100 kΩ
resistor
33 / 88
Advertisement
Table of Contents
