Mower Belt Replacement - Toro TITAN Service Manual

Mower Belt Replacement

Mower Belt Removal
Mower Belt Installation
Mower Deck: Service and Repairs
1. Park the machine on a level surface and disengage the PTO. Stop the engine,
wait for all moving parts to stop, and remove key. Engage the parking brake
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Lower the mower deck to the 76 mm (3 inches) height-of-cut position.
4. Remove the bolts from the covers and lift covers off the deck.
g322061
5. Using a spring removal tool remove the spring tension from the idler pulley.
6. Lower the deck to the lowest height of cut position and secure the pin to
lock in position.
7. Remove the belt from the deck pulleys and the clutch pulley.
1. Route the new belt around the clutch pulley and deck pulleys.
g322062
2. Install the idler spring using the spring removal tool.
3. Ensure that the belt is properly seated in all pulleys.
Figure 76
Figure 77
Page 7–6 Titan Service Manual
3438-774 Rev A