Park Brake Handle Assembly Installation (continued)
Titan Service Manual
3438-774 Rev A
g321541
1.
Screw
2.
Wave Washer
3.
Flange Nut
2. With the park brake handle hardware oriented as shown, install the bolt
through the brake detent and connect the flange nut. Torque to 23 ± 3 N•m
(200 ± 25 in-lb).
g321540
1.
Cotter Pin
2.
Intermediate Brake Rod
3.
Torx Screw
4.
Flange Bushing
3. Install the intermediate brake rod and secure with locking cotter pin.
4. Cycle the park brake lever to ensure that it locks in the engaged position.
5. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 50
4.
Washer
5.
Flange Pivot
Figure 51
5.
Wave Spring
6.
Brake Flanged Bushing
7.
Flange Nut
Page 5–25
Chassis: Service and Repairs