Toro TITAN Service Manual page 50

Seat Removal (ZX Models Only)
Seat Installation (ZX Models Only)
Chassis: Service and Repairs
1. Park the machine on a level surface and disengage the PTO. Stop the engine,
wait for all moving parts to stop, and remove key. Engage the parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Disconnect the wire harness connector at the operator presence switch.
4. Remove the cotter pins from the stop rod on the left and right sides of the
seat.
5. Slide the rod toward the inside of the seat pan to release the seat from the
frame, then slide it the opposite way to release it from the other side.
6. Lift the seat assembly off of the machine.
1. Verify that the fuel tank hold down is seated properly in the front and rear of
the frame and secured with the hold down bolt.
g321203
2. Place the seat on top of the fuel tank and align the hole in one side of the
frame with the hole in the seat plate.
3. Install the stop rod and secure with one cotter pin.
4. Slide the rod toward the outside of the machine while aligning the hole on the
opposite side with the hole in the frame.
5. Insert the stop rod to secure the seat in place and install the cotter pin.
6. Raise the seat and connect the wire harness terminal to the operator
presence switch.
7. Lift and lower the seat to verify proper function of the seat pivots and the
seat latch.
8. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
9. Verify proper function of the unit.
Figure 28
Page 5–12 Titan Service Manual
3438-774 Rev A