Toro TITAN Service Manual page 59

Throttle Control Assembly Installation
Titan Service Manual
3438-774 Rev A
1. Route the throttle cable through the right console.
g321452
2. Snap the throttle control assembly into place.
3. Install the control panel assembly into the console.
4. Move the throttle control lever to the full speed position.
g322343
5. Place the z bend of the throttle cable in the throttle plate on the engine in
the position previously noted.
6. Place the cable under the cable clamp.
7. Ensure that the throttle control lever is in the fast idle position.
Note: Pull on the cable and verify the engine is at full throttle, then tighten
the clamp.
g321453
Figure 43
Figure 44
Figure 45
Page 5–21 Chassis: Service and Repairs