Toro TITAN Service Manual page 32

Toro Twin Cylinder Engine Removal (continued)
Toro Twin Cylinder Engine Installation
Engine: Service and Repairs
g321706
12. Disconnect the throttle cable.
13. Disconnect the choke cable.
14. Remove the clutch mounting bolt and washer. Slide the clutch off of the
crankshaft.
15. Remove the engine pulley.
16. Remove the engine mounting bolts.
17. Lift the engine away from the frame.
1. Prepare the frame and secure any fuel lines or wire harness components.
2. Lower the engine onto the frame.
3. Align the four holes of the engine base to the frame and attach the 2 rear
mounting bolts and two flat washers loosely.
Note: Apply Loctite 243 to engine mounting bolts.
4. Attach the front bolt through the clutch anchor and into the engine base.
Figure 8
Page 4–6 Titan Service Manual
3438-774 Rev A