Toro TITAN Service Manual page 91

Mower Spindle Disassembly
Mower Spindle Assembly
Titan Service Manual
3438-774 Rev A
g322066
1. Spindle Nut
2. Pulley
3. Bearing Shield
4. Spindle Mounting Screws
5. Spindle Assembly
1. Clamp the spindle for service by placing the spindle shaft in a vise.
2. Remove the nut and washer from the top of the pulley.
3. Remove the pulley.
4. Remove spindle housing from the shaft.
5. Remove the bearing shield.
6. Remove the bearing and the bearing spacer from the top of the spindle
housing.
7. Flip over the spindle housing and remove the lower bearing.
8. Inspect the inside of the spindle housing for wear or damage.
1. Inspect the inside of the spindle housing for wear or damage.
2. Press the top bearing into the spindle housing by pressing equally on the
inner and outer race.
Note: Ensure that the bearing seats against the shoulder in the spindle
housing.
Figure 79
6. Spindle (Apply Anti-Seize)
7. Blade
8. Belleville Washer
9. Blade Bolt
Page 7–9 Mower Deck: Service and Repairs