Toro TITAN Service Manual page 74

Hydrostatic Drive Belt Removal (continued)
Hydrostatic Drive Belt Installation
Hydrostatic Drive System: Service and Repairs
g321838
9. Remove the drive belt from the hydrostatic drive pulleys.
Note: Inspect the belt for excessive wear, damage, or cracking, replace
if necessary.
1. Route the hydrostatic drive belt around the two transmission pulleys.
2. Route the drive belt around the engine pulley.
3. Install the idler arm and pulleys.
Note: Make sure that the belt is properly routed before installation.
g321833
4. Install the clutch stop.
5. Verify proper routing of the belt.
6. Place the idler spring onto the idler arm loop and use a spring removal tool to
secure the spring (A) into the slot on the right rear of the frame.
Figure 60
Figure 61
Page 6–8 Titan Service Manual
3438-774 Rev A