Toro TITAN Service Manual page 94

Electric PTO Clutch Installation
Mower Deck: Service and Repairs
g322063
1. Engine Pulley to Shaft (Apply Anti-Seize)
2. Bolt
3. Clutch Stop Mount
1. Install the clutch on to the crankshaft ensuring that the slot in the clutch aligns
with the tab on the clutch anchor and the rubber isolator is in place.
Note: Apply anti-seize to the end of the pulley shaft.
2. Apply thread lock to the clutch bolt.
3. Install the washer and clutch mounting bolt. Torque the clutch bolt to 76 ±
7 N • m (55 ± 5 ft-lb).
4. Connect the clutch power wire to the clutch.
Note: Ensure wire harness is properly routed to avoid contact with the mower.
g322060
Figure 82
4. Clutch Isolator
5. PTO Clutch
6. Clutch Mounting Bolt (Apply Loctite)
Figure 83
Page 7–12 Titan Service Manual
3438-774 Rev A