Toro TITAN Service Manual page 65

Motion Control Assembly Removal (continued)
Motion Control Assembly Installation
Adjust the Motion Control Handle
Titan Service Manual
3438-774 Rev A
g321539
1. Position the motion control assembly in place with the linkage extending
toward the transmission.
2. Secure the motion control assembly to the frame.
3. Connect the motion control linkage to the motion control assembly.
4. Connect the motion control damper to the motion control assembly.
5. Connect the motion control handle to the motion control assembly using
the two bolts.
6. Adjust the neutral setting.
7. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
8. Lower the unit and verify proper function.
9. Adjust the tracking if necessary.
Note: Ensure proper adjustment of neutral and tracking settings before adjusting
the motion control handles.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop, and remove key.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Move the levers into the operating position.
4. Loosen the 2 bolts that secure the motion control handles to the motion
control assembly.
5. Align the levers front to back and secure the bolts.
Figure 53
Neutral Adjustment (page 6–4)
Tracking Adjustment (page 6–5)
Page 5–27 Chassis: Service and Repairs