Toro TITAN Service Manual page 54

Seat and MyRIDE™ Platform (MR Models Only) Removal (continued)
Seat and MyRIDE™ Platform (MR Models Only) Installation
Chassis: Service and Repairs
g321447
11. Tilt the MyRIDE® assembly one way. Unhook the fuel line keeper from
under the seat.
12. Lift the entire MyRIDE® assembly up and away from the main frame.
Removing the MyRIDE® assembly will take two or more people.
Note: Do not remove either of the swing arm rods from the swing arm
underneath the machine. This could cause damage or misalignment of the
MyRIDE® suspension platform.
1. Verify that the fuel tank hold down is seated properly in the front and rear of
the frame and secured with the hold down bolt.
g334861
1. Vent Line
2. Lower the MyRIDE® assembly onto the main frame, aligning the frame
brackets on each side with the mating holes in the main frame. Reconnect
the fuel line keeper under the seat.
Figure 34
Figure 35
2. Liquid Line
Page 5–16 Titan Service Manual
3438-774 Rev A