Toro TITAN Service Manual page 57

Fuel Tank Removal (continued)
Fuel Tank Installation
Titan Service Manual
3438-774 Rev A
1. Park the machine on a level surface and disengage the PTO. Stop the engine,
wait for all moving parts to stop, and remove key. Engage the parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the right and left consoles.
Right Console Replacement (page 5–8)
4. Reinstall the fuel cap.
5. Remove the seat assembly (ZX models) or the MyRIDE™ Platform Assembly
(MR models).
6. Remove the fuel tank hold down rod and bolt.
7. Disconnect the fuel supply line and the bent line from the fuel tank.
8. Rotate and lift the fuel tank assembly from the machine.
g321450
1. Fuel Tank Hold-Down Rod
2. Fuel Supply Line
1. Position the fuel tank assembly and rotate it onto the frame with the vent
ports toward the rear of the machine.
2. Connect the vent line to the fuel tank.
3. Connect the fuel supply line to the fuel tank.
Note: Make sure that the fuel lines are routed towards the hold down rod
and in the recess of the fuel tank.
4. Install the fuel tank hold down rod and bolt.
5. Install the seat assembly.
6. Install the right and left consoles.
Right Console Replacement (page 5–8)
7. Install the fuel cap by sliding the d-ring into the neck of the fuel tank. Secure
the fuel cap to the tank.
8. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Left Console Replacement (page 5–6)
Figure 40
3. Vent Line
Seat Replacement (zx Models Only) (page 5–11)
Left Console Replacement (page 5–6)
Page 5–19 Chassis: Service and Repairs