Caster Wheel Bearing Installation
Left Console Replacement
Left Console Removal
Chassis: Service and Repairs
1. Install new bearings (bearings may have a slight press fit).
Note: The bearings are sealed and do not require grease/lubrication. They
may also have a slight press fit.
2. Install the spanner into the caster wheel, then install felt washers and dust
caps over the caster bearings.
3. Place the caster wheel inside of the caster fork, aligning the spanner with
the holes in the caster fork.
4. Install the bolt and nut and torque to 44 ± 7 N• m (32 ± 5 ft-lb).
5. Lower the unit and verify proper function.
6. Install new bearings (bearings may have a slight press fit).
7. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Park the machine on a level surface and disengage the PTO. Stop the engine,
wait for all moving parts to stop, and remove key. Engage the parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the 3 (T30) shoulder screws from the left console.
g321205
4. Remove the fuel cap and disconnect the keeper line.
Figure 19
Page 5–6
Titan Service Manual
3438-774 Rev A