Toro TITAN Service Manual page 61

Choke Control Assembly Installation (continued)
Titan Service Manual
3438-774 Rev A
g321454
3. Attach the choke cable assembly to the control panel with the jam nut.
4. Install the control panel assembly into the console.
5. Move the choke control lever to the open position (down).
6. Place the z bend of the choke cable in the choke plate on the engine in the
position previously noted.
7. Place the cable under the cable clamp.
8. Ensure that the choke control lever is pressed down fully and tighten the
cable clamp .
g323084
9. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 47
Figure 48
Page 5–23 Chassis: Service and Repairs