Toro TITAN Service Manual page 37

Kawasaki Engine Installation (continued)
Titan Service Manual
3438-774 Rev A
3. Align the four holes of the engine base to the frame and attach the two rear
mounting bolts and two flat washers loosely.
Note: Apply Loctite 243 to engine mounting bolts.
4. Attach the front bolt through the clutch anchor and into the engine base.
5. Install the 3 remaining engine bolts.
6. Torque the 4 engine mounting bolts to 52 ± 5.8 N • m (450 ± 50 in-lb).
7. Apply anti-seize to the clutch end of the crankshaft.
8. Install the engine pulley onto the crankshaft.
9. Install the clutch on to the crankshaft ensuring that the slot in the clutch aligns
with the tab on the clutch anchor.
10. Install the washer and clutch bolt.
Note: Apply Loctite to the clutch bolt.
11. Torque the clutch bolt to 69-83 N • m (50-60 ft-lb).
12. Connect the choke cable.
13. Connect the throttle cable.
14. Connect the black engine ground wire.
Note: Apply Loctite to ground bolt.
15. Connect the red wire to the starter.
g321704
16. Connect the chassis wire harness to the main engine wire harness.
17. Connect the fuel supply line to the fuel pump.
18. Connect the vent line to barb/splice.
19. Install the hydrostatic drive belt.
20. Install the mower belt.
21. Install the muffler and new exhaust.
Note: Torque muffler mounting bolts or nuts to 17-20 N • m (150-170 in-lb).
Figure 16
Page 4–11 Engine: Service and Repairs