Insert Module Next To The Controller - Spectrum Controls Micro800 2085sc-IF16C User Manual

Expansion i/o 16-channel analog input module
Hide thumbs Also See for Micro800 2085sc-IF16C:
Table of Contents

Advertisement

Description
1
Mounting screw hole/mounting foot
2
Removable Terminal Block (RTB)
3
RTB hold down screws
You can choose to wire the plug-in before inserting it into the controller or wire
it once the module is secured in place.
NOTE

2.4.1 Insert Module Next to the Controller

Follow the instructions to insert and secure the plug-in module to the controller:
NOTE
NOTE
This equipment is considered Group 1, Class A industrial
equipment according to IEC/CISPR 11. Without appropriate
precautions, there may be difficulties with electromagnetic
compatibility in residential and other environments due to
conducted and radiated disturbance.
Be careful when stripping wires. Wire fragments that fall into the
controller could cause damage. Once wiring is complete, make
sure the controller is free of all metal fragments before removing
the protective debris strip.
Do not wire more than 2 conductors on any single terminal.
If you insert or remove the expansion I/O module while power is
on, an electrical arc can occur. This could cause an explosion in
hazardous location installations. Be sure that power is removed or
the area is nonhazardous before proceeding.
Cable length should be less than 10 meters.
The module expansion may only be mounted horizontally.
For environments with greater vibration and shock concerns, use the panel
mounting method, instead of DIN rail mounting.
Chapter 2: Installation and Wiring
Description
4
Module interconnect latch
5
DIN rail mounting latch
6
I/O Status LED
User's Manual Pub. 0300306-02 Rev. B
2-5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Micro800 2085sc-IF16C and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Micro800 2085sc-if16v

Table of Contents