ILMOR One-Drive Owner's Manual page 48

SECTION 4 ILMOR ONE-DRIVE OWNER'S MANUAL
4-16
b. If necessary, add oil until an air-free stream of oil flows from the oil
vent hole.
c. Install the oil vent plug and gasket. Torque the oil vent plug.
NOTICE: Oil level in the oil reservoir will rise and fall during stern-drive
operation; always check the level when the stern-drive is cool and the
engine is shut down.
Lubricating the Drive Unit and Universal-joint Shaft Splines and
O-rings
When you remove the stern-drive unit from the transom assembly, your
should first remove the quick connect fitting. This will prevent oil leaks
from the reservoir tank.
Remove the drive unit and lubricate the universal-joint shaft splines
(Figure 4-16, 1) and the O-rings (Figure 4-16, 2).
1
Figure 4-15
2
Figure 4-16
© 6/2016 Ilmor Marine Engines, Version 1.0