ILMOR One-Drive Owner's Manual page 47

OPERATING
RANGE Line
14. Ensure that the rubber gasket is inside the cap and install the cap.
NOTICE: Never over-tighten.
15. Remove the pump from the oil fill/drain hole. Quickly install the gasket
and oil fill/drain plug. Torque the oil fill/drain plug.
Oil fill/drain plug torque
N·m
15
16. Check the oil level in the oil reservoir after first use.
17. Check the stern-drive oil level within one week of the first use as
follows:
a. Remove the oil vent plug (Figure 4-14, 1) and gasket (Figure 4-14, 2).
© 6/2016 Ilmor Marine Engines, Version 1.0
Oil reservoir cap
Figure 4-13
Figure 4-14
lb-ft
11
2
1
MAINTENANCE
4-15