Installing The Propellers - ILMOR One-Drive Owner's Manual

Problems associated with propellers include ventilation, cavitation and
blow-out. These problems have similar symptoms and are best diagnosed
by an expert. If a propeller related problem develops, consult your Ilmor
Marine dealer or distributor.

INSTALLING THE PROPELLERS

2
1
7
8
1. Rear propeller nut
2. Rear propeller
3. Rear propeller thrust hub
4. Front propeller nut
1. Apply a liberal coat of lubricant to the propeller shaft. Recommended
lubricants are shown in the table below.
Urea grease water resistant type, NLGI #2
Lithium grease with PTFE
2. Slide the forward thrust hub onto the propeller shaft with the tapered
side toward the propeller hub (toward end of propeller shaft).
3. Align the splines and place the propeller on the propeller shaft.
4. Install and torque the front propeller nut. Check the propeller at least
every 20 hours.
N·m
135
© 6/2016 Ilmor Marine Engines, Version 1.0
4
3
5. Front propeller
6. Front propeller thrust hub
7. Propeller shaft anode
8. Propeller shaft anode bolt and washer
Figure 3-1
Description
Front propeller nut torque
STERN-DRIVE OPERATION
6
5
Where used
Propeller shaft
lb-ft
99
3-2