ILMOR One-Drive Owner's Manual page 40

SECTION 4 ILMOR ONE-DRIVE OWNER'S MANUAL
4-8
Retorquing the Gimbal Ring to Steering Shaft Connection
Torque the gimbal ring locknuts (Figure 4-3, 1) for the steering shaft
connection.
Gimbal ring locknut torque
N·m
50
Inspecting the Bellows and the Clamps
See General Inspection on page 4-4.
Checking the Engine Alignment
Consult your authorized Ilmor Marine dealer or distributor.
Lubricating the Steering Shaft Bushing
Apply approximately 8 to 10 pumps of grease to the steering shaft bushing
grease fitting (Figure 4-4, 1). Use a typical hand-operated grease gun to
apply the grease.
Description
Urea grease water resistant type, NLGI #2
Figure 4-3
1
Figure 4-4
© 6/2016 Ilmor Marine Engines, Version 1.0
1
lb-ft
37
Where used
Steering shaft
bushing