Table of Contents
Advertisement
MAINTENANCE
POWER TRIM PUMP FLUID
Power trim fluid does not require changing unless it becomes
contaminated with water or debris. Consult your authorized Ilmor Marine
dealer or distributor if the power trim fluid needs to be changed.
PERIODIC MAINTENANCE PROCEDURES
Weekly
Perform the following procedures on a weekly basis.
• Checking the water inlets
• Checking the seawater inlet hole
• Inspecting the anodes
• Checking the oil level
Checking the Water Inlets
Check the water inlets for debris or marine growth. Clean if necessary.
Checking the Seawater Inlet Hole
Check the seawater inlet hole. Clean if necessary.
Inspecting the Anodes
Inspect the anodes and replace if 50 % corroded. See Corrosion Protection
on page 2-4.
Checking the Oil Level
Check the stern-drive oil level within one week of the first use as follows:
1. Remove the oil vent plug (Figure 4-1, 1) and gasket (Figure 4-1, 2).
2
1
Figure 4-1
2. If necessary, add oil until an air-free stream of oil flows from the oil
vent hole.
4-5
© 6/2016 Ilmor Marine Engines, Version 1.0
Advertisement
Table of Contents
