ILMOR One-Drive Owner's Manual page 42

SECTION 4 ILMOR ONE-DRIVE OWNER'S MANUAL
4-10
Grease the steering cable grease fitting.
1. Turn the steering wheel until the steering cable is fully retracted into
the cable housing. Apply approximately three pumps of grease from a
typical hand-operated grease gun.
NOTE: If the steering cable does not have a grease fitting, the inner wire of
the cable cannot be greased.
Description
Lithium grease with PTFE
2. Turn the steering wheel until the steering cable (Figure 4-6, 1) is fully
extended. Lightly lubricate the exposed part of the cable.
Description
Urea grease water resistant type, NLGI #2
3. Lubricate the steering system clevis pin (Figure 4-7, 1).
Description
Urea grease water resistant type, NLGI #2
Where used
Steering cable
1
Figure 4-6
Where used
Steering cable
1
Figure 4-7
Where used
© 6/2016 Ilmor Marine Engines, Version 1.0
Clevis pin