General Inspection - ILMOR One-Drive Owner's Manual

SECTION 4 ILMOR ONE-DRIVE OWNER'S MANUAL
Lubricate the cables and the
linkages
Retorque the rear engine mounts
Lubricating the drive unit and
universal-joint shaft splines and
O-rings
Replace U-joint bellows
Replace control cable bellows
Replace of friction disc (Light
duty commercial applications
only)
4-4
¡: Check or clean ¯: Replace
Daily
See Daily Checks
on page 3-4
If operating in only freshwater, this maintenance may be extended to every four months.
1
Light duty commercial applications
2
Every 150 hours or every year, whichever comes first
3
Lubricate engine coupler every 50 hours if operated at idle for prolonged periods of time.
4
Every 2 years
5
Every 1000 hours or every year, whichever comes first
6

GENERAL INSPECTION

Inspect the stern-drive at regular intervals to help maintain top operating
performance and correct potential problems before they occur.
Check for loose, damaged or missing parts, hoses and clamps. Tighten or
replace as needed.
Check the electrical connections and leads for damage and corrosion.
Remove and inspect the propeller. If it is badly nicked, bent or cracked,
consult your authorized Ilmor Marine dealer or distributor.
Repair nicks and corrosion damage on stern-drive exterior finish. Never
use paint containing copper or tin. This will damage the stern-drive
and void the warranty. Use a high quality primer and topcoat paint
specifically designed for aluminum outboards or stern-drives. Follow the
manufacturer's directions for surface preparation and application.
: Consult your authorized Ilmor Marine dealer or distributor
l
Every
Weekly 50
Hours
Every Every
100 250
Hours Hours
¡
¡
l
Every
1000
hours
l
6
¯
© 6/2016 Ilmor Marine Engines, Version 1.0
Every
Year
¡
¡
Every 2
years
l
5
¯
Every 2
years
l
¯ 5
l
¯ 6