Additional Protection - ILMOR One-Drive Owner's Manual

SECTION 2 ILMOR ONE-DRIVE OWNER'S MANUAL
2-6

Additional Protection

In addition to the corrosion protection devices, take these steps to inhibit
corrosion:
1. Paint the stern-drive. See Touching-Up the Stern-Drive Paint and Spray
with Corrosion Guard on page 4-11.
2. Spray stern-drive components on the inside of the vessel annually
with corrosion guard to protect the finish from dulling and corrosion.
External stern-drive components may also be sprayed.
3. Keep all lubrication points, especially the steering system, shift and
throttle linkages, well-lubricated.
4. Flush the coolant system periodically, preferably after each use.
NOTICE: Replace anodes if eroded 50 percent or more.
NOTICE: Anytime the boat is left in the water and the engine is not
running, the drive must be left in the fully down position. This will keep
the anodes in the water and will keep the exhaust pipe engaged with
the exhaust port of the drive.
I-CaPS
electrode
Propeller shaft
anodes
Trim cylinder anodes
Ventilation
plate anode
Figure 2-3
© 6/2016 Ilmor Marine Engines, Version 1.0
Gear
housing
anodic
plates