ILMOR One-Drive Owner's Manual page 31

3. The oil level is low if it is below the MIN line (Figure 3-5, 1) on the
reservoir. Fill as necessary with the specified fluid. See Fill the Power
Trim Pump Fluid on page 3-8.
Fill the Power Trim Pump Fluid
NOTE: The power trim fluid does not require changing unless it becomes
contaminated with water or debris. Consult your authorized Ilmor Marine
dealer or distributor if the power trim fluid needs to be changed.
1. Place the stern-drive in the full DOWN/TRIM-IN position.
2. Unscrew and remove the fill cap assembly (1) from the reservoir (3)
with specified fluid.
Description
Dextron III Automatic transmission fluid
© 6/2016 Ilmor Marine Engines, Version 1.0
1
Figure 3-5
Power trim pump
STERN-DRIVE OPERATION
Where used
3-8