ILMOR One-Drive Owner's Manual page 46

SECTION 4 ILMOR ONE-DRIVE OWNER'S MANUAL
4-14
NOTICE: If any water drains from the oil fill/drain hole, or if it appears
milky, the stern-drive may be leaking and should be checked
immediately by your authorized Ilmor Marine dealer or distributor.
8. Remove the case plate cover (Figure 4-12, 4), filter cover (Figure 4-12, 3),
magnet (Figure 4-12, 2) and filter (Figure 4-12, 1). Clean or replace the
filter and magnet.
9. Lower the stern-drive so that the propeller shaft is level. Fill the
stern-drive through the oil fill/drain hole with the specified oil until
an air-free stream of oil flows from the filter opening. Install the filter,
magnet, filter cover and case plate cover.
10. Continue to fill the stern-drive with oil through the oil fill/drain hole
until an air-free stream of oil flows from the oil vent hole.
11. Install the oil vent plug and gasket. Torque the oil vent plug.
N·m
15
12. Continue to pump gear oil into the oil reservoir circuit until the gear
oil appears in the oil reservoir.
13. Fill the oil reservoir so that the oil level is within the operating range
(Figure 4-13).
NOTICE: Never overfill.
Model
One-Drive
* Quick Silver is a registered trademark of Brunswick Corporation.
2 3
1
Figure 4-12
Oil vent plug torque
Capacity
2500 ml Quick Silver
(85 oz) Performance Gear Lube
© 6/2016 Ilmor Marine Engines, Version 1.0
4
lb-ft
11
Fluid type
* High
®