After Initial 50 Hours Of Operation - ILMOR One-Drive Owner's Manual

SECTION 4 ILMOR ONE-DRIVE OWNER'S MANUAL
4-6
3. Install the oil vent plug and gasket. Torque the oil vent plug.
N·m
15

After Initial 50 Hours of Operation

Perform the following procedures after the first 50 hours of operation.
• Lubricating the engine coupler
• Changing the stern-drive oil
Lubricating the Engine Coupler
Lubricate the engine coupler every 50 hours if operated at idle for
prolonged periods of time.
NOTE: The stern-drive may be equipped with a sealed engine coupler. The
sealed coupler and shaft splines can be lubricated without removing the
stern-drive.
Apply approximately 8 to 10 pumps of grease to the engine coupler grease
fitting (Figure 4-2, 1) to lubricate the engine coupler splines through the
grease fittings, if equipped. Use a typical hand-operated grease gun to
apply the grease.
1
Description
Multi-purpose heavy-duty type lithium grease,
NLGI #2
NOTE: Lubricate the coupler on the One-Drive model every 50 hours if the
vessel is operated at idle for prolonged periods of time.
Oil vent plug torque
Figure 4-2
© 6/2016 Ilmor Marine Engines, Version 1.0
lb-ft
11
Where used
Coupler