ILMOR One-Drive Owner's Manual page 28

SECTION 3 ILMOR ONE-DRIVE OWNER'S MANUAL
3-5
1. Check the stern-drive oil level (Figure 3-2). Keep the oil level at or
near the OPERATING RANGE (full) line (Figure 3-2, 3) on the oil
reservoir (Figure 3-2, 1).
2. The oil level is low if it is below the ADD line (Figure 3-2, 2) on the oil
reservoir (Figure 3-2, 1). Fill as needed with the specified oil. See Fill
the Stern-Drive with Oil on page 3-5.
NOTICE: If any water is visible at the bottom of the oil reservoir or
appears at the oil fill/drain plug and/or if oil appears discolored, consult
your authorized Ilmor Marine dealer or distributor immediately. Both
conditions may indicate a water leak somewhere in the stern-drive.
Fill the Stern-Drive with Oil
See Changing the Stern-Drive Oil on page 4-7 when filling the entire
stern-drive.
NOTICE: If more than 60 ml (2 fl oz) of gear oil is required to fill the
reservoir, a seal may be leaking. Damage to the stern-drive may occur
because of lack of lubrication. Consult your authorized Ilmor Marine
dealer or distributor.
1
3
2
Figure 3-2
© 6/2016 Ilmor Marine Engines, Version 1.0