ILMOR One-Drive Owner's Manual page 29

1. Remove the oil reservoir cap (Figure 3-3, 1).
2. Fill the oil reservoir to the OPERATING RANGE (Figure 3-3, 2) (full)
line with specified fluid.
NOTICE: Do not overfill.
Description
MV8 Quick Silver
series
* Quick Silver is a registered trademark of Brunswick Corporation.
3. When replacing the cap, ensure that the rubber gasket is inside the oil
reservoir cap and install the cap. Do not over-tighten.
© 6/2016 Ilmor Marine Engines, Version 1.0
1
2
Figure 3-3
* High Performance
®
Gear Lube
STERN-DRIVE OPERATION
Where used
Oil reservoir
3-6