Table of Contents
Advertisement
Handheld Rapid Scan
Fill holes
The default does not check the mark point and fill hole, check the fill hole you need set
perimeter, choose 10-100mm perimeter to fill the hole, less than the perimeter of the hole will
be filled. Mark point fill hole as an example.
After
Note：
1. If the edge of the hole is not smooth may cause the effect is not good, not
recommended to fill hole.
2. Hole-filling: choose 10-100mm perimeter to fill the hole;
Smooth
The data to denoise processing, improve data quality, the figure before and after smoothing:
Before smooth
Sharpen
Improve the overall clarity of the data, the figure below before and after sharpening:
Before
After smooth
43
Advertisement
Table of Contents
Need help?
Do you have a question about the EinScan-Pro+ and is the answer not in the manual?