Shining 3D EinScan-Pro+ User Manual page 41

Handheld Rapid Scan
Undo
You can only undo the last deleted data.
Show/Hide Stripes
Click the button to switch the texture display and hide. Non-texture scan,
there is no such button.
Done
Click the button when scanning data is complete to save the data.
Note：
1. When new project choose the high resolution, the slow it saves, please be
patient.
2. After click done， if you continue to close the program Data loss may occur.
Please wait.
Delete whole data
Click the button to delete the whole data and restart scanning. If the surface of the
object has mark points, the software will recognize the mark points and scan. Without mark
point , it will use feature alignment.
Mesh
When the scan is completed, click the botton, proceed to post-processing. You will see
two modes after clicking the button: Watertight and Unwatertight. Watertight usually slower
than unwatertigt. Texture scan mode will take more time compared to Non-Texture scan mode.
Watertight
Closed model can be printed directly. After choose this mode, you should select the
object details.
Select High for objects with fine texture, select Med or Low for objects in smooth
surface or with less detail. The time for data processing is in relation to the detail setting. The
higher the level of details is, the longer time the processing takes. It may keep for a long time in
95%, please be patient.
Select the object details：
40