Epson RS-353 Service Manual page 98

5.2 Image Adjustment Program
This program is provided on a floppy disk to provide the adjustment functions
summarized in the table below.
Table 5-2
    
    
 
  
When running this program, prepare a host computer and a monitor and connect them
with the LCP-attached computer cable and an RS-232C cable. Insert the floppy disk
containing the image adjustment program in the drive in the host computer and run the
system on the host computer. A menu screen appears. Run the menu options and
program the resultant settings onto the flash ROM on the main board.
Computer cable
RS-232C cable
Conditions that require the adjustments provided by the image
5.2.1
adjustment Program
The table below lists the conditions that require the adjustments to be conducted under
control of the image adjustment program.
Table 5-3

   
   
   
 

After completing the focus alignment, you should obtain the best display quality by
using Image adjustment program. This program specify the electrical parameters
in order to obtain best display quality.
 
Monitor cable
Host
Computer
Figure 5-16

 
 
  

Monitor