Advertisement
Removing the Interface Unit Assembly
Prerequisite condition: The step explained in Subsections 3.2.1, 3.2.4 must have been
completed.
1. Remove the GND cable mounting screw.
Screw:
P/N1033122
2. Remove two interface unit assembly mounting screws.
Screw:
P-Tight: P/N1021824 (mounting torque:
3. Remove the fan hold plate mounting screw,
Screw:
P/N1033122 (mounting torque:
4. Slide the interface unit slightly inward not to contact the frame, before removing it.
Caution:
When installing the interface board
the screw holes) in the board with
screws.
GND cable/Screw
Figure
assembly, align the two positioning holes (beside
the bosses on the bracket before tightening the
3-17
=
=
=
Advertisement
