Advertisement
3.2.5 Removing the Exhaust Fan Unit
Prerequisite condition: The step explained in Subsections 3.2.1 must have been
completed.
Screw
1. Disconnect the cable connected to the connector (CN503).
2. Remove four mounting screws from the fan hold plate to detach the fan with the hold
plate.
Screw:
P Tight P/N1021824 (mounting torque:
Screw:
P/N1033122 (mounting torque:
3. Remove two exhaust fan unit mounting screws to separate the fan from the hold
plate.
Screw:
Bind: P/N1022793 (mounting torque:
Caution:
1) When installing the exhaust fan, take care with the orientation of it. Installing the fan
in the reverse orientation may result in a device failure or extended cooling time
because of an overheat condition. Make sure that the label on the fan faces outward.
2) The exhaust fan unit and its peripherals are susceptible to dust and dirt. When
installing the exhaust fan unit, check its cleanness and clean it if necessary.
Fan hold
fan
Figure
13
Figure
14
3-10
=
=
=
Advertisement
